|
If contracts stops printing near the end of a form it is because your printer has detected that you are "out of paper". The steps below are used to change a setting to make sure that your forms print all the way to the bottom
Step By Step
| 1. | Be sure the printer is turned on place a sheet of plain white paper in the printer. |
| 2. | Press the MODE button on the front of the printer (this is the second button from the left). |
| 3. | Press the PRINT button once (the description for the button is found underneath the button, it's the same as the TOF/Quiet button) When you press this a listing of all the changeable features for the printer will print. |
| 4. | Press the GROUP button once. Then press the ITEM button three times. A line reading "PAPER OUT OVERRIDE" should have printed. You want this to read "YES". If it says "NO" then press the SET button once - this will change the line to read "PAPER OUT OVERRIDE YES". |
| 6. | Press the FORM FEED button. |
| 7. | Turn your printer off and turn it on again and your printer should now print and feed all contracts and other forms properly. |
|